Knowledgebase

Portal Home > Knowledgebase > Articles Database > PPS Rate Limiting?

PPS Rate Limiting?

Posted by 0x01-Security, 05-06-2013, 07:07 PM

I've read on the Cisco IOS documentation that with QoS policies you can rate limit source connections based on bits per second but I haven't seen anything about packets per second. Is it possible to rate limit source IPs based on packets per second? If so how would this be achieved?

---

Posted by mummy, 05-07-2013, 11:20 AM

I am not entirely sure this is applicable in your case, yet it may be the key to your quest: http://www.cisco.com/en/US/docs/swit...if_cmds_r.html

---

Posted by alanwoo, 05-07-2013, 12:35 PM

Depends on your switch, for common Cisco Switch, 2950, 2960, 3750 etc, the pps limit is set on interface/port level, not based on ip address.

---

Add to Favourites    Print this Article

mesopia and bad Support (Views: 688)

HostForWeb or Hosteasier (Views: 705)

Blocking Access From a Referring URL (Views: 740)

Rapidswitch down? (Views: 758)

looking for 8+ GB RAM VPS (Views: 761)